Hello...I hope that you are all well!
I took a long break from home recording (5-6 years) but have been doing some things on the AW1600 over the past few weeks. It's nice to be back.
I recorded some tracks tonight (two guitars, two vocals, bass, stereo drums)....when i created the stereo mix I noticed that the right VU meter was showing a much higher peak/louder signal than the left. I checked the levels on the various tracks, the left/right pan, the effects, etc. Couldn't get the left and right volumes to even out.
I burned the mix onto a CD and transfered it into Sound Forge on my desktop PC. The right channel wav file is much bigger/louder.
My question...is there something I'm missing that controls the volume going into or out of the stereo bus? Sorry if my terminology isn't correct, but I find the manual excruciatingly hard to understand.
Any advice or ideas would be greatly appreciated. Thanks! - Bob in Connecticut.